How To Wash Wood After Sanding
While blowing the dust off with compressed air removes the dust it also mixes it into the air so some of it can settle back onto the surface and so you can breath it.
How to wash wood after sanding. Mix the cleaner according to the instructions on the bottle and allow it to soak into the wood for 15 minutes. You can knock down the fuzz by sanding -- as long as you wait for the wood to dry. Sanded hardwood floor lacks a protective layer and therefore you cannot use water or liquid cleaner on it.
In order to remove the last remnants of the old finish then you must use a medium grit sandpaper. They are very handy if you need to de-grease anything. Pour the mineral spirits over the stripped area and use the steel wool to wipe away any remaining stripper residue be sure to follow the wood grain.
It is not that difficult and not that expensive. Sanding against it might cause irremovable scratches on the surface. Wipe down the whole surface with a tack cloth to remove any dust from sanding.
You will need a few hours to. Wood dust from sanding will cause problems if its not removed from the surface before staining. Wipe the folded tack cloth across the wood.
Inspect the tack cloth periodically to see how much dust you are collecting and change the tack cloth whenever it gets dirty. Water spots or stains may also form on the surface. After stripping paint to properly clean the wooden surface use mineral spirits and fine steel wool.
As an optional step you can apply wood cleaner and brightener. It is good to use a shop vac to clean the surface between sanding grits removing the larger grit particles from the wood before sanding with the next higher grit. When exposed it will absorb water or the cleaner and warp.