How To Turn Spindles On A Wood Lathe

The tenons were cut by mounting the blanks in the Spigot Jaws of the chuck and running the lathe at a very slow speed.

How to turn spindles on a wood lathe. Nov 7 2018 - Explore Ray Browns board Spindle followed by 293 people on Pinterest. Use the square-end tool to turn a ¼-inch groove in the back of the blank leaving a ⅜ outer rim of wood. If the finished spindle will retain a square segment youll need to first turn a pommel the transition from square to round.

Most woodturning projects on the lathe are started by using a roughing gouge to create the basic shape whether a spindle bowl bottle stopper or nearly any other woodturning project. When the grain of the turning blank is at right angles to the lathe then you are doing faceplate or bowl turning. The aluminum fingers must be free to move up and down.

They would fell a tree of suitable wood then buck sections of the bole the trunk between the roots and the first branches into lengths suitable for the spindles they intended to turn. Keep working your way along the spindle removing the corners from a square portion of the blank toward a rounded portion. Prepare a spindle of appropriate length.

To make the blank round mount it on the lathe between the headstock and tailstock and use the roughing gouge to reduce it to a cylinder. Widen the groove to prevent the tool from grabbing. When turning spindles I like to cut a crosshatch into the ends of the turning blank so the workpiece centers quickly and seats solidly on the lathe.

Adjust the height of the tool rest to match the tool you are using. Unless curly the bole is clear wood because there are no emanating branches that cause a knot. Turn the workpiece to create a cylinder that.

Start at one end and remove the corners Photo 10a. Your drive spur makes the wood spin and the live center helps to hold it on the lathe. With the spindle and machine set up complete youre ready to cut woodUsing a spindle gouge and holding the chisel approximately parallel to the floor gently probe the tip of the chisel into the spinning spindle.