How To Prepare Raw Wood For Painting

I then gave the whole board one coat of satin polyurethane.

How to prepare raw wood for painting. This process is called popping the grain. Follow these steps for a great finish. Httphow-to-paintinfo How to prepare and paint new wood or timber surfaces this video goes through the process of painting wood surfaces like trim.

Apply a coat of white alkyd undercoat and let it dry for three to four hours. So once you purchase a wood panel you need to do two important steps before painting. Sanding is critical t.

If there is mould dirt grease or anything else present we must remove and clean it before we can begin applying any type of coating. Wood knots moisture sap bleeding will affect the coating if not prepared properly. When painting any substrate we must always begin with a clean dirt and grease free surface.

Apply your primer this is a must for wood. The top quarter is satin poly on raw wood the one underneath is satin poly over 3 coats of dead flat then satin poly over 2 coats of dead flat and finally the bottom quarter is satin poly over 1 coat of dead flat. Anywhere two pieces of wood butt.

Once the primer has fully dried apply the top coat. If you choose this method make sure you only use a wet rag to apply the water. White vinegar for heavily soiled unfinished wood that has sticky residue or similar film buildup.

Wet the wood if you dont want to use conditioner. Some experts recommend using water instead of conditioner to prepare the wood for staining for the same effect. Raw wood panels need to be sealed prior to priming and painting to keep moisture from getting to the wood which causes warping and other damage.