How To Polish Paint After Wet Sanding

Soak for at least 60.

How to polish paint after wet sanding. Allow the surface to dry. Fill a bucket with slightly soapy water and let your sandpaper soak in it for up to an hour before you begin then wrap it around a soft colour sanding block. If this was a two-stage paint you would only be sanding the clear coat and the water will only turn milky.

Tutorial video on how to wet sand paint to achieve a high gloss finish remove any imperfections in the paint surface remove orange peal and achieve a mirr. The detergent reduces the surface tension of the water which is great to wet the material thoroughly. Trying to get the surface flat with 1500 paper is a challenge.

This video will show you how to wet sand and polish your vehicle after spray paintingHow To Wet Sand and Polish After Spray Painting CarPlease Shop and see. Always pre-soak the sandpaper ensure the area is wet and work evenly across the surface. Once you have completely cleaned your body allow it to dry by gently wiping down the surface with a towel.

Essentially wet sanding is the process of sanding a car with water. In this video I show you how you can properly wet sand and polish the clear coat on your car. Be sure your surface is clean and dry remove all contaminants Use only when temperatures range between 50F and 90F where relative humidity is below 85 Begin and finish spraying off the object using a side-to-side sweeping motion overlapping your spray slightly with each pass Paint can be recoated within an hour Paint fully cures in 24 hours.

I originally released a wet sanding tutorial video back in 2013 so this is my updated version covering commonly asked ques. If you cut your sandpaper correctly it will fold in three equal parts. Coarser will get you there.

How to wet sand and polish paint. Once the wet sanded area is completely dry apply some rubbing compound to a buffer pad and use a power buffer to polish the. I JUST started using the 600 grit method after polishing an almost flat surface to a mirror finish and then having to sand again because it wasnt flat enough in the first place.