How To Make Your Own Wood Turning Lathe

Its easier to clean it up now that after it gets hard.

How to make your own wood turning lathe. Considering that electric motors commonly come at 2400 or 2800 RPM as well as the cheaper low speed ones finding the right motor is part of the fun of creation. There are not a lot of parts needed to make a nice Wood Lathe Tool. If playback doesnt begin shortly try restarting your device.

Building your own wood lathe is truly a simple matter. Old-school faceplate turning often involves gluing your turning stock here a piece of cherry to a sacrifical piece of wood in the photo a piece of pine that is in turn screwed to the faceplate. Nut Type Compression Tube Size 34 In Tube Outside Dia.

4-jaw Lathe Chuck for Woodturn. Mine is a 10 pound 125 horsepower motor and it has never slowed down while I am turning something. Make sure you clamp up the handles nice and tight wipe off any excess epoxy that oozes out from the handles being squeezed together.

To begin with if your were searching for wood turning tools with carbide tips you might have a hard time finding them because these special tools are made with carbide inserts. Both my father and I have used vacuum cleaner motors to build both metal and wood turning lathes. I will not go into excessive detail here because everyones motor setup will vary.

Usually a piece of 12 steel round or square notched out in the end to accept a small square round or triangular carbide cutter that is screwed onto the steel shaft and the far side of the shaft has a long wood handle. How to Make Lathe Chuck. You need to move this to the side when you are putting wood onto the lathe.

I think I used a 30 minute epoxy to glue the handles together. 34 In Thread Size 1-18 Thread Connection Material of Construction Brass. Woodturnings popularity is on the rise and for good reason.