How To Make Wood Carvings Shine

3 Apply a coat of oil or wax to preserve the wood finish.

How to make wood carvings shine. Dab a small amount of beeswax or linseed walnut or tung oil onto a clean cloth and rub it over the completed ring inside and out. Step 3 Once a year move your carving to a flat covered surface clean it with your dry brush and apply two coats of polyurethane spray. Wipe it onto the surface to fill in any pores in the wood.

Not on your carving take a piece of wood make few cuts in it in different directions and different depth and stainpaint it. You can then sand it with a higher grit abrasive over your coats of finish to achieve smoothness. Apply additional polish to the brush as need.

Take clear pore filler and with a paint sponge. It should lose roughness to the eye but a slight roughness will remain to the hand. Take your 60-grit sandpaper and sand down all the carvings surfaces by hand.

For wax-polishing carved work benzine wax is preferred to turpentine wax because it does not clog the tine lines and notches so much. Always work in the wood grain direction to avoid scratches and damage and use as little liquid and apply as. Read the instructions of the manufacturer about drying time.

There are a few ways you can go about making wood shiny and smooth. One of them is by using high gloss and shine varieties of polyurethane or lacquer when choosing a finish. Use a large soft paperhangers brush or hogs hairbrush on the sculpture s particularly if the piece is old fragile and shows signs of deterioration.

Not on your carving take a piece of wood make few cuts in it in different directions and different depth and stainpaint it. You have put a lot of work into a wood carving. It should lose roughness to the eye but a slight roughness will remain to the hand.